X35 Monitor Air Seeder Setup
6.4
Figure 6.2 - Copy Implement
Copy
3. To copy an existing profile and make the
required changes:
a. Select the implement you would like to
copy (it will have white background).
The copy button will appear, refer to
Figure 6.2.
b. Select
the copy button.
i. A window informing you that this
operation will require a restart will
appear.
ii. Click OK (green check mark) to
continue or click the red "X' to
cancel the operation.
c. If creating a copy, the "New implement as
Copy" window will appear.
i. Select an implement name button to
give it a new name and confirm.
d. If required, make changes to the settings
like implement geometry, sectional control
(if applicable), operator inputs, seeder
(granular tank, NH3/Liquid tank, fans, etc).
To Next Page
Loading...
