Wartsila RT-flex50-D User Manual

Maintenance8752−1/A2 RT-flex50-D
Wärtsilä Switzerland Ltd
2/ 5
2. Removal
Remark: Always start removing a fuel pressure pipe by disengaging its upper end.
⇒ Loosen all screws 4 and remove mounting clamps 5 from holders 17 and 17a.
⇒ Loosen screws 6 and 7.
⇒ Push up flange 8 as much as possible.
⇒ Push down flange 8a as much as possible.
⇒ Press intermediate ring 10 together with fuel pressure piping 1 down by
approx. 2 mm and push the the latter sideways towards the engine.
⇒ Remove the intermediate ring together with the fuel pressure piping.
D Pay attention not to damage sealing faces ’DF’.
D All connections must be closed off immediately and the sealing faces must be
protected after removing the fuel pressure pipings.
C
12
I
II
3
11
8a
7
1
1
6
8
L
B
13
14
19
20
20
20
20
9
10
2 mm
019.071/09
II
I
I - I
II - II
5, 4
17a
17
5
4
F
uel Pressure Piping: Removing, Fitting and Regrinding 7 and 8 Cylinder Engine
s
2010 / 7 & 8 Cyl.

Wartsila RT-flex50-D Specifications

General

Brand	Wartsila
Model	RT-flex50-D
Category	Engine
Language	English