Chapter 8 Basic Setting
OLT2406 User’s Guide
103
Note: You must configure a VLAN first. Each VLAN can have multiple management IP
addresses, and you can log into the OLT via different management IP addresses
simultaneously.
Use this screen to configure the default gateway device, the default domain name server and add IP
domains.
Figure 64 Basic Setting > IP Setup
The following table describes the labels in this screen.
Table 20 Basic Setting > IP Setup
LABEL DESCRIPTION
Default
Gateway
Type the IP address of the default outgoing gateway in dotted decimal notation, for example
192.168.1.254.
Domain Name
Server
Enter a domain name server IPv4 address in order to be able to use a domain name instead of
an IP address.
Default
Management
Specify which traffic flow (In-Band or Out-of-band) the OLT is to send packets originating from
itself (such as SNMP traps).
Select In-Band to have the OLT send the packets to all ports except the management port
(labelled MGMT) to which connected device(s) do not receive these packets.
Select Out-of-band to have the OLT send the packets to the management port labelled MGMT.
This means that device(s) connected to the other port(s) do not receive these packets.
Management IP Address
Use these fields to set the settings for the out-of-band management port.
To Next Page
Loading...
