ZyXEL Communications OLT2406 - Pppoe IA for ONT Pppoe Option

Chapter 29 PPPoE
OLT2406 User’s Guide
259
The following table describes the labels in this screen.
29.3.3 PPPoE IA for ONT PPPoE Option
Use this screen to have:
• The OLT adds PPPoE options in the outgoing packets.
• The OLT drops/forwards the incoming packets with PPPoE options from an ONT.
See Table 104 on page 259 for more information.
Table 103 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN
LABEL DESCRIPTION
Show Port Enter a port number to show the PPPoE Intermediate Agent settings for the specified VLAN(s) on
the port.
Show VLAN Use this section to specify the VLANs you want to configure in the section below.
Start VID Enter the lowest VLAN ID you want to configure in the section below.
End VID Enter the highest VLAN ID you want to configure in the section below.
Apply Click Apply to display the specified range of VLANs in the section below.
Port This field displays the port number specified above.
VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the *
VLAN, the settings are applied to all VLANs.
* Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Note: Changes in this row are copied to all the VLANs as soon as you make them.
Circuit-id Enter a string of up to 63 ASCII characters that the OLT adds into the Agent Circuit ID sub-option
for this VLAN on the specified port. Spaces are allowed.
The Circuit ID you configure here has the highest priority.
Remote-id Enter a string of up to 63 ASCII characters that the OLT adds into the Agent Remote ID sub-
option for this VLAN on the specified port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a specific port, the OLT
automatically uses the PPPoE client’s MAC address.
The Remote ID you configure here has the highest priority.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 104 PPPoE Options
PPPOE GLOBAL PPPOE OPTION
PPPOE PASS
THROUGH
ACTION
Disabled Disabled/Enabled Disabled • The OLT won’t add PPPoE options in the
outgoing packets.
• The OLT drops the incoming packets with
PPPoE options from an ONT
Disabled Disabled/Enabled Enabled • The OLT won’t add PPPoE options in the
outgoing packets.
• The OLT forwards the incoming packets with
PPPoE options from an ONT