Chapter 91 Routing Table
OLT2406 User’s Guide
641
CHAPTER 91
Routing Table
91.1 Routing Table Overview
The routing table contains the route information to the network(s) that the OLT can reach. The OLT
automatically updates the routing table with the RIP information received from other Ethernet devices.
91.2 Routing Table Commands
The following section lists the commands for this feature.
Table 344 Routing Table Commands
COMMAND DESCRIPTION M P
interface route-domain <ip-
address>/<mask-bits>
Configures a route-domain setting and enters
the sub-commands for configuring it.
ip-address: the IP address already created.
mask-bits: the mask bits of the IP address, 0-32.
C13
ip rip direction
<Outgoing|Incoming|Both|None>
version <v1|v2b|v2m>
Configures the RIP setting of the specified route-
domain.
direction: the outgoing or incoming RIP
packets to be sent or processed. You can also
specify both or none.
version: the RIP version to be sent and
processed.
v1: the OLT will send out RIP packets with v1
format, and only process v1 RIP packets.
v2b: the OLT will send out RIP packets with v2
broadcast format, and process v1, v2
broadcast, and v2 multicast RIP packets.
v2m: the OLT will send out RIP packets with v2
multicast format, and process v1, v2 broadcast,
and v2 multicast RIP packets.
C13
router rip
Enables RIP and enters the sub-commands for
configuring RIP settings.
C13
distance <10-255>
Sets the RIP route distance. C 13
no router rip
Disables the RIP feature. C 13
show router rip
Displays the RIP configuration. E 3
show ip route
Displays the IP routing table. E 3
To Next Page
Loading...
