ZyXEL Communications OLT2406 - Management Switching Card Control Commands Examples; Port-Level Protect Switch Commands

Chapter 97 Management Switching Card Control
OLT2406 User’s Guide
689
97.2.1 Management Switching Card Control Commands Examples
This example displays management switching card state and firmware version information from
execution mode.
This example displays management switching card state and firmware version information from
configuration mode.
This example copies the active management switching card’s running firmware to the standby
management switching card’s running firmware.
97.3 Port-level Protect Switch Commands
With port-level protect-switch enabled, the active MSC changes roles to stand-by mode if all uplink port
links go down. The following section lists the commands for this feature.
OLT2406(config)# msc
Slot State Update F/W Ver.
-------------------------------------
*1 active v V4.00(AAOP.1)C0 | 2015-02-03
2 - v
next boot: 1
Update target: All
OLT2406# configure
OLT2406(config)# msc
Slot State Update F/W Ver.
-------------------------------------
*1 active v V4.00(AAOP.1)C0 | 2015-02-03
2 - v
next boot: 1
Update target: All
OLT2406# configure
OLT2406(config)# msc sync ras
...........................................................
OLT2406(config)# send ras to standby msc…
########################################
Table 365 Port-level Protect Switch Commands
COMMAND DESCRIPTION M P
show protect-switch msc
Displays the port-level protect-switch
configuration. See Chapter 98 on page 691 for
information about protect-switch groups.
E 3
protect-switch msc port-level
enable
Turns on port-level protection. C 13
no protect-switch msc port-level
enable
Disables port-level protection. C 13