ZyXEL Communications OLT2406 - UNI Port PVID Settings

Chapter 96 Remote ONT
OLT2406 User’s Guide
682
This example deletes 3 protocol-based VLAN rules on ONT-5-1-3 uniport-1-1.
This example shows protocol-based VLAN rules on ONT-5-1-3 uniport-1-1.
96.4.5 UNI Port PVID Settings
Use the pvid command to configure UNI port default VLAN settings.
This example sets up PVID on uniport-1-1 of ONT-5-1-3. Untagged packets from port 1 of ONT-5-1-3 will be
tagged by the ONT with VID 203 and priority bit 2.
This example deletes the PVID on uniport-1-1 of ONT-5-1-3.
OLT2406 (config-remote-uniport)# no protocol-based ipoe
OLT2406 (config-remote-uniport)# no protocol-based pppoe
OLT2406 (config-remote-uniport)# no protocol-based arp
OLT2406# show remote uniport uniport-5-1-3-1-1 protocol-based
Uniport Ether type Vlan Priority
----------------- ---------- ---- --------
uniport-5-1-3-1-1 ipoe 103 4
uniport-5-1-3-1-1 pppoe 203 0
uniport-5-1-3-1-1 arp 103 4
Table 358 UNI Port PVID Command Parameters
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
pvid [VID|SVID:CVID] [def-pbit
<priority>] [active <on | off>]
Configures default VLAN settings for the UNI
port.
VID|SVID:CVID: The default VLAN ID the ONT
applies to untagged packets it receives from
the subscriber ports.
def-pbit: The priority bit (0~7) the ONT inserts in
the packets to which it applies the PVID.
active: Enable or disable the PVID rule.
C13
no pvid
Deletes default VLAN settings for the UNI port. C 13
show remote uniport <aid> pvid <cr>
Displaysthe specified UNI port’s default VLAN
settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
E13
OLT2406 (config)# remote uniport uniport-5-1-3-1-1
OLT2406 (config-remote-uniport)# pvid 203 def-pbit 2 inactive
OLT2406 (config)# remote uniport uniport-5-1-3-1-1
OLT2406 (config-remote-uniport)# no pvid