ZyXEL Communications OLT2406 - Syslog Upload Setup

Chapter 46 Syslog Setup
OLT2406 User’s Guide
382
Figure 239 Management > Syslog > Syslog Server Setup
The following table describes the labels in this screen.
46.4 Syslog Upload Setup
Click Management > Syslog > Syslog Upload Setup in the navigation panel to display this screen. Use this
screen to set up the time when the file with log messages will be uploaded to an external syslog server.
You can also set up the login information on an external syslog server.
Table 182 Management > Syslog > Syslog Server Setup
LABEL DESCRIPTION
Syslog Server Setup
Active Select this check box to have the OLT send logs to this syslog server immediately when these
logs are generated. Clear the check box if you want to create a syslog server entry but not
have the device send logs to it (you can edit the entry later).
Server Address Enter the IPv4 address of the syslog server.
Log Level Select the severity level(s) of the logs that you want the device to send to this syslog server.
The lower the number, the more critical the logs are.
Add Click Add to save your changes to the OLT’s run-time memory. The OLT loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to return the fields to the factory defaults.
Index This is the index number of a syslog server entry. Click this number to edit the entry.
Active This field displays Yes if the device is to send logs to the syslog server. No displays if the
device is not to send logs to the syslog server.
IP Address This field displays the IP address of the syslog server.
Log Level This field displays the severity level of the logs that the device is to send to this syslog server.
Delete Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry(ies).
Cancel Click Cancel to begin configuring this screen afresh.