Chapter 8 Basic Setting
OLT2406 User’s Guide
104
8.7 Port Setup
Use this screen to configure OLT port settings. Click Basic Setting > Port Setup in the navigation panel to
display the configuration screen.
IP Address Enter the out-of-band management IP address of your OLT in dotted decimal notation. For
example, 192.168.0.1.
IP Subnet
Mask
Enter the IP subnet mask of your OLT in dotted decimal notation, for example, 255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for example,
192.168.0.254
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
IP Interface
Use these fields to create or edit IP routing domains on the OLT.
IP Address Enter the IP address of your OLT in dotted decimal notation, for example, 192.168.1.1. This is the
IP address of the OLT in an IP routing domain.
IP Subnet
Mask
Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.255.0.
VID Enter the VLAN identification number to which an IP routing domain belongs.
Add Click this to create a new entry.
This saves your changes to the OLT’s run-time memory. The OLT loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
IP Address This field displays IP address of the OLT in the IP domain.
IP Subnet Mask This field displays the subnet mask of the OLT in the IP domain.
VID This field displays the VLAN identification number of the IP domain on the OLT.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the OLT.
Cancel Click Cancel to clear the check boxes.
Table 20 Basic Setting > IP Setup
LABEL DESCRIPTION
To Next Page
Loading...
