Chapter 85 Access Control
OLT2406 User’s Guide
614
85.3 SNMP Server Commands
Use these commands to configure SNMP on the OLT.
The following table describes user-input values available in multiple commands for this feature.
The following section lists the commands for this feature.
Table 321 SNMP Switch Traps
OPTION OBJECT LABEL OBJECT ID DESCRIPTION
stp STPNewRoot 1.3.6.1.2.1.17.0.1 This trap is sent when the STP root switch changes.
MSTPNewRoot 1.3.6.1.4.1.890.1.5.17.3.107.70.1 This trap is sent when the MSTP root switch
changes.
STPTopologyChange 1.3.6.1.2.1.17.0.2 This trap is sent when the STP topology changes.
rmon RmonRisingAlarm 1.3.6.1.4.1.890.1.5.1.1.16.0.1 This trap is sent when a variable goes over the
RMON "rising" threshold.
RmonFallingAlarm 1.3.6.1.4.1.890.1.5.1.1.16.0.2 This trap is sent when the variable falls below the
RMON "falling" threshold.
cfm dot1agCfmFaultAlarm 1.3.111.2.802.1.1.8.0.1 The trap is sent when the OLT detects a
connectivity fault.
Table 322 SNMP Server Commands User-input Values
COMMAND DESCRIPTION
property
1-32 alphanumeric characters
options
aaa: authentication, accounting.
interface: linkup, linkdown,
autonegotiation, lldp, transceiver-ddm.
ip: ping, traceroute.
switch: stp, mactable, rmon, cfm.
system: coldstart, warmstart, fanspeed,
temperature, voltage, reset, timesync,
intrusionlock, loopguard, poe.
Table 323 SNMP Server Commands
COMMAND DESCRIPTION M P
show snmp-server
Displays SNMP settings. E 3
snmp-server <[contact <system-
contact>] [location <system-
location>]>
Sets the geographic location and the name of
the person in charge of this OLT.
system-contact: 1-32 English keyboard
characters; spaces are allowed.
system-location: 1-32 English keyboard
characters; spaces are allowed.
C13
To Next Page
Loading...
