Chapter 69 Port Authentication
OLT2406 User’s Guide
500
Display port ge-5-1’s 802.1X port authentication settings.
69.4 MAC Authentication Commands
This table lists the commands for this feature.
OLT2406# show port-access-authenticator ge-5-1
port ge-5-1
Active : Yes
Authorized : No
Reauthenticate : Yes
Reauth-Period : 3600
Tx-period : 30
Quiet-period : 100
supp-timeout : 30
Max-req : 2
Guest-Vlan Active : Yes
Guest-Vlan : 1
Host-Mode : Multi-host
Table 253 MAC Authentication Commands
COMMAND DESCRIPTION M P
mac-authentication
Enables MAC authentication on the OLT.
Note: You must first enable MAC
authentication on the OLT before
configuring it on each port.
E3
no mac-authentication
Disables MAC authentication on the OLT. C 13
interface port-channel <aid>
Enters the sub-commands for configuring the
specified interfaces.
aid: <msc|ge|pon>-<slot>-<port>
C13
mac-authentication
Enables MAC authentication on the ports. You
must first allow MAC authentication on the OLT
before configuring it on each port.
C13
no mac-authentication
Disables MAC authentication on the ports. C 13
exit
Leaves the interface configuration sub-
commands.
C13
mac-authentication nameprefix
<name-string>
Sets the prefix the OLT appends to all MAC
addresses it sends to the RADIUS server for
authentication. The prefix can be up to 32
printable ASCII characters.
If you don’t configure this, the OLT forwards only
the MAC address of the client to the RADIUS
server.
C13
mac-authentication password <name-
string>
Sets the password the OLT sends along with the
MAC address for authentication with the RADIUS
server. The password can be up to 32 printable
ASCII characters.
C13
To Next Page
Loading...
