Chapter 54 Basic Settings
OLT2406 User’s Guide
421
54.10 Port Setup
The following table describes the commands for configuring ports.
Table 203 Port Setup Commands
COMMANDS DESCRIPTION M P
show interfaces config <aid>
Displays port settings.
aid: slot-<slot> | <ge|msc|pon>-<slot>-
<port>
E3
baudrate <1|2|3|4|5>
Changes the console port baud rate (in bps).
1: 38400
2: 19200
3: 9600
4: 57600
5: 115200
E13
interface port-channel <aid>
Enters the sub-commands for configuring the
specified interface.
aid: <msc|ge|pon>-<slot>-<port>
C13
name
Sets the interface name. C 13
speed-duplex <auto|100-
full|1000-full|2500-
full|10000-full>
Sets the interface speed (in Mbps) and duplex
mode.
auto: (auto-negotiation) allows one port to
negotiate with a peer port automatically to
obtain the connection speed and duplex mode
that both ends support. When auto-negotiation
is turned on, a port on the OLT negotiates with
the peer automatically to determine the
connection speed and duplex mode. If the peer
port does not support auto-negotiation or turns
off this feature, the OLT determines the
connection speed by detecting the signal on
the cable and using half duplex mode. When
the OLT’s auto-negotiation is turned off, a port
uses the pre-configured speed and duplex
mode when making a connection, thus
requiring you to make sure that the settings of
the peer port are the same in order to connect.
100-full is supported for a 1000Base-T
connection.
1000-full is supported by both 1000Base-T
and 1000Base-X connections.
2500-full is supported by the SC optical
transceiver connections.
10000-full is supported by the 10 Gigabit
Ethernet uplink connections.
C13
To Next Page
Loading...
