ZyXEL Communications OLT2406 - Voip SIP Profile Commands

Chapter 78 VoIP
OLT2406 User’s Guide
565
78.3 VoIP SIP Profile Commands
The following table lists the commands for configuring VoIP SIP profiles.
jitter-buf-max <0~500>
Sets the maximum depth (from 0 to 500) of the
jitter buffer in milliseconds.
C13
jitter-target <0~500>
Sets the target value (from 0 to 5000) of the jitter
buffer in milliseconds.
C13
local-port <1~65535>
Sets the RTP port to use for voice traffic. C 13
oob-dtmf <enable|disable>
Turns out-of-band DTMF carriage on or off. C 13
piggyback
Turn RTP piggyback events on or off. C 13
pstn-protocol <0~999>
Sets which variant (from 0 to 999) of POTS
signalling to use on the associated UNIs.
C13
signalling-code <loo-str|gro-
str|loo-rev|coi-fir|dia-
ton|mul-par>
Sets the signaling code:
loo-str: Loop start
gro-str: Ground start
loo-rev: Loop reverse battery
coi-fir: Coin first
dia-ton: Dial tone first
mul-par: Multi-party
C13
tone <enable|disable>
Turns the handling of tones through RTP tone
events according to RFC 4733 on or off.
C13
Table 294 VoIP Common Profile Commands (continued)
COMMAND DESCRIPTION M P
Table 295 VoIP SIP Profile Commands
COMMAND DESCRIPTION M P
voip-sip-profile <name>
Creates the specified profile of VoIP SIP settings
(1 to 15 character name) and enters the sub-
command mode for configuring it.
C13
bridged-line-agent-uri <1~63
characters>
Sets the bridged line agent URI (from 1 to 63
characters). An interaction SIP bridge enables
agents to use an IP telephone at a remote
location through a TCP/IP network to a
Customer Interaction Center.
C13
call-present <features>
Configures the list of supported call presentation
features. You can specify multiple options
separated by commas without spaces; for
example: cal-for,dia-ton.
spl-rin: Message waiting indication splash ring
dia-ton: Message waiting indication special
dial tone
vis-ind: Message waiting indication visual
indication
cal-for: Call forwarding indication
C13