ZyXEL Communications OLT2406 - Creating a VLAN; Initial Setup Example; Overview

OLT2406 User’s Guide
72
CHAPTER 5
Initial Setup Example
5.1 Overview
This chapter shows how to set up the OLT for an example network.
The following lists the configuration steps for the initial setup:
• Create a VLAN
• Set port VLAN ID
• Configure the OLT IP management address
5.1.1 Creating a VLAN
VLANs confine broadcast frames to the VLAN group in which the port(s) belongs. You can do this with
port-based VLAN or tagged static VLAN with fixed port members.
In this example, you want to configure port 10 as a member of VLAN 5.
See Table 21 on page 86 about mappings of VLAN ports and physical ports.
Figure 41 Initial Setup Network Example: VLAN
1 Click Advanced Application > VLAN > Static VLAN in the navigation panel.