OLT2406 User’s Guide
327
CHAPTER 40
Static Route
40.1 Static Routing Overview
This chapter shows you how to configure static routes.
The OLT uses IP for communication with management computers, for example using HTTP, Telnet, SSH, or
SNMP. Use IP static routes to have the OLT respond to remote management stations that are not
reachable through the default gateway. The OLT can also use static routes to send data to a server or
device that is not reachable through the default gateway, for example when sending SNMP traps or
using ping to test IP connectivity.
This figure shows a Telnet session coming in from network N1. The OLT sends reply traffic to default
gateway R1 which routes it back to the manager’s computer. The OLT needs a static route to tell it to
use router R2 to send traffic to an SNMP trap server on network N2.
Figure 200 Static Routing Overview
40.1.1 What You Can Do
• Use the Static Routing screen (Section 40.2 on page 327) to configure and enable an IPv4 static route.
40.2 Static Routing
Use this screen to configure and enable an IPv4 static route. Click IP Application > Static Routing in the
navigation panel to display the screen as shown.
To Next Page
Loading...
