Chapter 78 VoIP
OLT2406 User’s Guide
570
78.5 UNI Port VoIP Service Settings
The following table lists the commands for configuring VoIP service settings for a subscriber port on the
remote ONT. The remote ONT must also support the VoIP services you configure for it.
Table 297 UNI Port VoIP Service Commands
COMMAND DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
voip-service mode sip
vlan <1-4094>
common-profile <name>
sip-profile <name>
[dial-plan <name>]
[username <name>]
[password <password>]
[aor <url>]
[disp-name <name>]
[vmail-url <uri>]
[vmail-extimer <0~3600>]
[release-timer <0~30>]
[roh-timer <0~30>]
Configures UNI port VoIP settings.
mode: sip mode (SIP) is supported.
vlan: Specify the VLAN ID (1 to 4094) for the UNI
port to use for VoIP traffic.
common-profile: Specify the name of an
existing SIP common profile.
sip-profile: Specify the name of an existing
SIP profile.
dial-plan: Specify the name of an existing dial
plan table.
username: The username (from 1 to 25
characters) for VoIP authentication.
password: The password (from 1 to 25
characters) for VoIP authentication.
aor: The user identification part of the address of
record (from 1 to 63 characters).
disp-name: The customer ID used for the display
attribute in outgoing SIP messages (from 1 to 25
characters).
vmail-url: The IP address or URL (from 1 to 63
characters) of the SIP voicemail server for
signaling messages.
vmail-extimer: The voicemail subscription
expiration time (from 0 to 3600) in seconds
(default 3600).
release-timer: The release timer (from 0 to 30)
defined in seconds (default 10).
roh-timer: The time (from 0 to 30) in seconds
for deciding the receiver is off hook (default is
15).
C13
voip-service help
Provides more information about the specified
command.
C13
To Next Page
Loading...
