Chapter 43 Maintenance
OLT2406 User’s Guide
348
The following table describes the labels in this screen.
43.3 Load Factory Default
Follow the steps below to reset the OLT back to the factory defaults.
1 Click the Click Her button next to the Load Factory Default field.
2 Click OK to continue or Cancel to abort.
Figure 213 Load Factory Default: Start
If you want to access the OLT web configurator again, you may need to change the IP address of your
computer to be in the same subnet as that of the default OLT IP address (192.168.1.1 or DHCP-assigned
IP).
43.4 Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on the OLT.
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the OLT.
Table 163 Management > Maintenance
LABEL DESCRIPTION
Current This field displays which configuration (Configuration 1 or Configuration 2) is currently operating
on the OLT.
Config This field displays the firmware that was loaded to the OLT.
Firmware
Upgrade
Click Click Here to go to the Firmware Upgrade screen.
Restore
Configuration
Click Click Here to go to the Restore Configuration screen.
Backup
Configuration
Click Click Here to go to the Backup Configuration screen.
Load Factory
Default
Click Click Here to reset the current configuration of the OLT. Note that this will not reset the
configuration to the factory default settings.
Save
Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the OLT.
Click Config 2 to save the current configuration settings to Configuration 2 on the OLT.
Reboot System Click Config 1 to reboot the system and load Configuration 1 on the OLT.
Click Config 2 to reboot the system and load Configuration 2 on the OLT.
Note: Make sure to click the Save button in any screen to save your settings to the
current configuration on the OLT.
To Next Page
Loading...
