OLT2406 User’s Guide
458
Figure 254 Static Multicast Forwarding to A Single Port
Figure 255 Static Multicast Forwarding to Multiple Ports
58.3 Static Multicast Forwarding Commands
Use the multicast-forward command to configure rules to forward specific multicast frames, such as
streaming or control frames, to specific port(s).
The following section lists the commands for this feature.
Table 227 Static Multicast Forwarding Commands
COMMAND DESCRIPTION M P
show mac address-table multicast
Displays the multicast MAC address table. E 3
multicast-forward name <name> mac
<mac-addr> vlan <vlan> inactive
Deactivates a static multicast forwarding rule.
The rule name can be up to 32 printable ASCII
characters.
mac-addr: Enter a multicast MAC address which
identifies the multicast group. The last binary bit
of the first octet pair in a multicast MAC address
must be 1. For example, the first octet pair
00000001 is “01” and 00000011 is “03” in
hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC
addresses.
vlan: A VLAN identification number.
Note: Static multicast addresses do not
age out.
C13
To Next Page
Loading...
