ZyXEL Communications OLT2406 - Bandwidth Control; Bandwidth Control Commands; Overview

OLT2406 User’s Guide
481
CHAPTER 64
Bandwidth Control
64.1 Overview
This chapter shows you how you can cap the maximum bandwidth using the bandwidth control
settings.
64.2 Bandwidth Control Commands
Bandwidth control means defining a maximum allowable bandwidth for out-going traffic flows on a
port.
The following table describes the related commands.
Table 241 Bandwidth Control Commands
COMMAND DESCRIPTION M P
bandwidth-control
Enables bandwidth control on the OLT. C 13
no bandwidth-control
Disables bandwidth control on the OLT. C 13
interface port-channel <aid>
Enters the sub-command mode for configuring
the specified ports.
aid: <msc|ge|pon>-<slot>-<port>
C13
bandwidth-limit cir <kbps>
Sets the ports’ Committed Information Rate
(CIR) bandwidth limit in Kbps.
C13
bandwidth-limit cir <cr>
Enables the CIR bandwidth limit on the port. C 13
bandwidth-limit egress
Enables bandwidth limits for outgoing traffic on
the ports.
C13
bandwidth-limit egress <kbps>
Sets the maximum bandwidth allowed for
outgoing traffic on the ports.
C13
bandwidth-limit pir <kbps>
Sets the ports’ Peak Information Rate (PIR)
bandwidth limit in Kbps.
C13
bandwidth-limit pir <cr>
Enables the PIR bandwidth limit on the ports. C 13
bandwidth-threshold egress
<kbps>
Sets the interface’s bandwidth rate threshold for
outgoing traffic.
The range of an XE port is from 0 to 10000000
Kbps.
The range of a GPON port is from 0 to 2500000
Kbps.
The range of a GE port is from 0 to 1000000
Kbps.
C13