OLT2406 User’s Guide
289
CHAPTER 35
ONT Reboot
35.1 Overview
Use this screen to restart an ONT without physically turning its power off, and load a firmware image
when it reboots.
35.2 The ONT Reboot Screen
Click Advanced Application > ONT Reboot in the navigation panel to display the screen as shown.
Figure 174 Advanced Application > ONT Reboot
The following table describes the labels in this screen.
Table 122 Advanced Application > ONT Reboot
LABEL DESCRIPTION
Select the GPON interface that the ONTs are connected to.
ONT AID This is the ONT’s ID in the format: uniport-<pon>-<ont>-<card>-<port>.
* means all ONTs.
Action Select a fimware file, current Image, Image1, or Image2, to load when the ONT reboot.
CheckApply Select the ONT(s) to reboot.
Apply Click Apply to reboot the ONT(s).
Cancel Click Cancel to begin configuring this screen afresh.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in
one screen.
To Next Page
Loading...
