ZyXEL Communications OLT2406 - Additional Commands; Chapter 108 Additional Commands; Command Summary; Overview

Chapter 108 Additional Commands
OLT2406 User’s Guide
724
CHAPTER 108
Additional Commands
108.1 Overview
Use these commands to manage the login session’s privilege level and CLI config mode or save the
current configuration in non-volatile memory.
108.2 Command Summary
The following section lists the commands for this feature.
Table 381 Command Summary: Changing Modes or Privileges
COMMAND DESCRIPTION M P
enable
Changes the session’s privilege level to 14 and
puts the session in enable mode (if necessary).
The user has to provide the enable password.
E0
enable <0-14>
Raises the session’s privilege level to the
specified level and puts the session in enable
mode if the specified level is 13 or 14. The user
has to provide the password for the specified
privilege level.
E0
disable
Changes the session’s priority level to 0 and
changes the mode to user mode.
E13
configure
Changes the mode to config mode. E 13
privilege mode <config|exec>
command <command> level <level>
Changes the privilege level of the specified
command.
C14
no privilege
Sets the privilege levels of all commands to
default settings.
C13
write memory [<index>]
Saves current configuration in non-volatile
memory to the configuration file the OLT is
currently using or the specified configuration file.
E13