Chapter 96 Remote ONT
OLT2406 User’s Guide
675
96.4.2 UNI Port Queue Settings
Use the queue command to configure a UNI port traffic class.
Table 355 UNI Port QoS Queue Command Parameters
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
queue tc <tc> priority
<priority> weight <weight>
usbwprofname <usbwprofname>
dsbwprofname <dsbwprofname>
dsoption <dsoption>
bwsharegroupid
<bwsharegroupid>
[<dsbwsharegroupid>]
Configures a UNI port QoS queue.
tc: The IEEE 802.1P QoS traffic class 0~7 of traffic
to which to apply this queue.
priority: 0~7. This is reserved for future
development since the Zyxel ONTs do not
support this QoS feature now.
weight: Queue weight: 0~255. You can
configure different queues with the same queue
priority level. The OLT then uses Weighted Round
Robin (WRR) scheduling to service these queues
on a rotating basis based on their queue weight.
The higher a queue’s weight, the more service it
gets. This is reserved for future development
since the Zyxel ONT do not support this QoS
feature now.
usbwprofname: The upstream bandwidth
profile to use for the traffic class.
dsbwprofname: The downstream bandwidth
profile to use for the traffic class.
dsoption: olt|ont. Set whether to apply the
downstream rate limit function to the OLT (olt) or
the ONT (ont).
bwsharegroupid: Specify the ID (1-40) of the
bandwidth group on this ONT to put the QoS
queues into. You created the bandwidth group
when you configured the ONT setup. The UNI
port will share the bandwidth defined by the
bandwidth group.
dsbwsharegroupid: Specify the ID (1-40) of
the downstream bandwidth group on this ONT
to put the QoS queues into. You can use this
when the dsoption is olt. You created the
bandwidth group when you configured the ONT
setup. The UNI port will share the downstream
bandwidth defined by the bandwidth group.
The OLT uses bwsharegroupid as the default
value.
C13
To Next Page
Loading...
