Chapter 38 ONT Template
OLT2406 User’s Guide
308
38.2.3 Uniport VLAN
Use this screen to configure UNI port VLAN flow settings. Click Uniport VLAN in the Advanced Application
> ONT Template screen to display the screen as shown.
You can also use VLAN stacking on the OLT. See Chapter 24 on page 191 for more information.
See Section 6.5 on page 85 for tutorials on how to use VLAN stacking on ONTs.
Figure 187 Advanced Application > ONT Template > Uniport VLAN
The following table describes the labels in this screen.
Delete Click Delete to remove the entries with the Delete option selected.
Cancel Click Cancel to begin configuring the screen again.
Table 133 Advanced Application > ONT Template > Uniport Queue (continued)
LABEL DESCRIPTION
Table 134 Advanced Application > ONT Template > Uniport VLAN
LABEL DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the first
drop-down list.
Choose the template that you want the settings configured here to apply to from the second
drop-down list.
Active Select this to enable the VLAN flow setting rule on the UNI port.
Uniport AID Select a UNI port on the ONT. The UNI ports are represented by the format: uniport-<pon>-<ont>-
<card>-<port>.
UNIVID
(SVID:CVID)
Enter the UNI Service provider VLAN ID (SVID) and Customer VLAN ID (CVID) (1~4094) of traffic on
the UNI port to which to apply the VLAN flow settings.
To Next Page
Loading...
