OLT2406 User’s Guide
92
The following table describes the labels in this screen.
7.2.1 Port Details
Click a number in the Port column in the Port Status screen to display individual port statistics. Use this
screen to check status and detailed performance data about an individual port on the OLT.
Table 15 Port Status
LABEL DESCRIPTION
Port This identifies the Ethernet and PON ports. Click a port number to display the Port Details screen
(refer to Figure 60 on page 93).
Name This is the name you assigned to this port in the Basic Setting > Port Setup screen.
Link This field displays the speed (either 100M for 100Mbps, 1000M for 1000Mbps, 2.5G for 2.5 Gbps, or
10G for 10 Gbps) and the duplex (F for full duplex or H for half). This field displays Down if the port
is not connected to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See STP Port
States on page 132 for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
Blocking.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on the
port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx kB/s This field shows the number of kilobytes per second transmitted on this port.
Rx kB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port has been up.
Clear Counter Select Port, enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
To Next Page
Loading...
