Chapter 92 Running Configuration
OLT2406 User’s Guide
644
The following section lists the commands for this feature.
92.4 Running Configuration Command Examples
This example resets the OLT to the factory default settings.
Table 347 Running Configuration Commands
COMMAND DESCRIPTION M P
show running-config
Displays the current configuration file. This file
contains the commands that change the OLT's
configuration from the default settings to the
current configuration.
E3
show running-config interface
port-channel <aid> [<options>
[<...>]]]
Displays the current configuration that applies to
the specified port.
aid: <ge|msc|pon>-<slot>-<port>
E3
show running-config help
Provides more information about the specified
command.
E3
show running-config page
Displays the current configuration file page by
page.
E3
show running-config vlanAID
Displays the current configuration file and lists
the port membership of each VLAN.
E3
copy running-config interface
port-channel <aid> <aid>
[<options> [<...>]]
Clones (copies) the attributes from the specified
port to other port. Optionally, copies the
specified attributes only.
E13
copy running-config help
Provides more information about the specified
command.
E13
copy running-config tftp <ip>
<remote-file>
Uses TFTP to back up the OLT’s current
configuration file to the TFTP server at the IP
address you specify. Specify the name to use for
the copied file.
E13
erase running-config
Resets the OLT to the factory default settings. E 13
erase running-config interface
port-channel <aid> [<options>
[<...>]]
Resets the specified port to the factory default
settings and optionally on a per-feature
configuration basis.
E13
erase running-config help
Provides more information about the specified
command.
E13
sync running-config
Uses the current configuration on the active
management switching card to update the
current configuration on the standby
management switching card.
E13
OLT2406# erase running-config
OLT2406# write memory
To Next Page
Loading...
