Chapter 96 Remote ONT
OLT2406 User’s Guide
678
96.4.3 UNI Port VLAN Settings
Use the vlan command to configure VLAN flow settings for the subscriber port on the remote ONT. See
Figure 268 on page 533 for where the VLAN IDs in the UNI port VLAN command fit in the reference
configuration defined in ITU-T G.984.1.
Table 356 UNI Port VLAN Command Parameters
LABEL DESCRIPTION M P
remote uniport <aid>
Configures UNI port settings.
aid: uniport-<slot>-<pon>-<ont>-<card>-
<port>
C13
vlan <UNIVID|SVID:CVID> [
network <VID|SVID:CVID> ] [
txtag <tag|untag|priotag>] [
pbitprof <prof> ] [ gemport
<gem-port> ] [ingprof <name>]
[aesencrypt <enable|disable>]
[TR156 <enable|disable>]
[sharepri <0-7 | off>] [macnum
<1-6>] [active <on|off>]
Configures UNI port VLAN flow settings.
UNIVID|SVID:CVID: UNI VLAN ID (1~4094) of
traffic on the UNI port to which to apply this
command's VLAN, QoS ingress profile, and AES
encryption settings.
network: The Network Node Interface (NNI) VID
to which the ONT translates the UNI VLAN ID
before sending traffic to the OLT. Use a number
different from the UNI VLAN to apply VLAN
translation.
txtag: Sets whether the ONT sends downstream
traffic with a VLAN tag or untagged.
gem-port: The GEM port to assign to the ONT
VLAN (range is 256 ~ ). A GEM port ID represents
a specific traffic flow or group of flows between
the OLT and one or more ONUs. The GEM port ID
is unique per GPON interface (see TR-156 for
more information).
ingprof: The QoS ingress profile to apply to the
VLAN’s traffic (IEEE 802.1p priority bit to TC
mapping profile).
C13
To Next Page
Loading...
