ZyXEL Communications OLT2406 - Listing Commands Available in a Command Mode

Chapter 51 CLI Introduction
OLT2406 User’s Guide
396
51.5 Listing Commands Available in a Command Mode
Use the help command to view the executable commands on the OLT. Follow these steps to create a
list of supported commands.
1 Log into the CLI. This takes you to execution mode.
2 Type help and press [ENTER] to display all the commands available in execution mode. Use execution
mode for show commands and system management.
3 Copy and paste the results into a text editor to create a list of all the executable commands in
execution mode.
4 Type config and press [ENTER] to enter configure mode. Use configure mode to configure features.
Type help and press [ENTER] to display all the commands and sub-commands available in configure
mode. The sub-commands are preceded by the command necessary to enter that sub-command
mode. For example, the command name <name-str> as shown next, is preceded by the command
used to enter the config-vlan sub-mode: vlan <1-4094>.
OLT2406# help
Commands available:
help
logout
exit
history
enable <0-14>
enable <cr>
disable
configure
mgmt-ont-img
fan <0-100>
fan auto
renew dhcp snooping database <tftp://host/filename>
renew dhcp snooping database <cr>
clear loopguard <cr>
clear logging
clear arp inspection filter
clear arp inspection log
clear arp inspection statistics <cr>
clear arp inspection statistics vlan <vlan-list>
clear interface <aid>
clear ip arp <cr>
clear ip arp interface port-channel <port-list>
clear ip arp ip <ip-address>
-- more --, next page: Space, continue: c, quit: ESC