ZyXEL Communications OLT2406 - IGMP Proxy Commands; Multicast Status

Chapter 76 Multicast
OLT2406 User’s Guide
536
76.2 Multicast Status
Use the show multicast command to display the multicast group information.
The following table describes the labels in the output.
76.3 IGMP Proxy Commands
Use the igmp-proxy commands to configure the IGMP proxy settings on the OLT. The following table
describes the commands options.
OLT2406# show multicast
Multicast Status
Total VID Multicast Group(Filter Mode) Timeout Up Time
[Source Address]
{IGMP channel, univid}
---------- ---- ---------------------------------------- ------- -----------
1 1001 225.1.1.1(EXCLUDE) 98 0:23:58
{uniport-5-1-1-4-1, 1001} Source IP
-------------------
1.5.1.1
Table 273 Multicast Status
LABEL DESCRIPTION
Total This field displays the number of groups that a port belongs to.
VID This field displays the multicast VLAN ID.
Multicast Group This field displays IP multicast group addresses.
Filter Mode This field displays the IGMP v3 filter mode of the group, such as INCLUDE or EXCLUDE.
Timeout This field displays the time in seconds after which the group will expire.
Up Time This field displays how long a port has belonged to a group.
Source Address This field displays the source IP address of a multicast server.
IGMP channel This field displays the port number that belongs to the multicast group.
univid This field displays the unicast VLAN ID for the IGMP channel.
Source IP This field displays the source IP address of a multicast client.
Table 274 igmp-proxy Commands
COMMAND DESCRIPTION M P
igmp-proxy
Enables IGMP proxy on the OLT. C 13
igmp-proxy ip <ip-address>
Sets the IGMP proxy’s working IP address. C 13
igmp-proxy v3mode
Enables IGMPv3 and MLDv2 modes. C 13
no igmp-proxy
Disables IGMP proxy on the OLT. C 13
no igmp-proxy v3mode
Disables IGMPv3 and MLDv2 modes. C 13
show igmp-proxy
Displays the IGMP settings. E 3