Chapter 76 Multicast
OLT2406 User’s Guide
546
76.9 MVR Group Configuration
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this
multicast group.
Configure MVR IP multicast group address(es) by the group command under mvr <vlan-id>.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
name <name-str>
Sets the MVR name for identification purposes.
name-str: 1-32 English keyboard characters
C13
receiver-port <aid>
Sets the receiver port(s). An MVR receiver port
can only receive multicast traffic in a multicast
VLAN.
aid: <ge|msc>-<slot>-<port>
C13
source-port <aid>
Sets the source port(s). An MVR source port can
send and receive multicast traffic in a multicast
VLAN.
C13
tagged <aid>
Sets the port(s) to tag VLAN tags. C 13
no mvr <vlan-id>
Removes an MVR configuration of the specified
VLAN from the OLT.
C13
no group <name-str> Removes the specified MVR multicast group. C 13
no inactive Enables the MVR settings. C 13
no receiver-port <ge|msc>-<slot>-<port> Disables the receiver port(s). An MVR receiver
port can only receive multicast traffic in a
multicast VLAN.
C13
no source-port <ge|msc>-<slot>-<port> Disables the source port(s). An MVR source port
can send and receive multicast traffic in a
multicast VLAN.
C13
no tagged <ge|msc>-<slot>-<port> Sets the port(s) to untag VLAN tags. C 13
Table 279 General MVR Configuration Commands (continued)
COMMAND DESCRIPTION
OLT2406# show mvr 10
MVLAN: 10 Active: Yes Mode: Dynamic 802.1p Priority: 0
Name:
Source Port: msc-1-1, msc-1-2, msc-1-3, msc-1-4
Receiver Port:
Tagged Port: msc-1-1, msc-1-2, msc-1-3, msc-1-4
MVR Group Configuration:
Name Start Address End Address
-------------------------------- --------------- ---------------
A0 224.1.1.1 224.1.1.255
To Next Page
Loading...
