Chapter 22 Policy Rule
OLT2406 User’s Guide
187
22.3 Displaying Policy Counter
Use this screen to display the dropped packets counters of the selected policy(ies) and port(s).
Click Advanced Applications > Policy Rule > Policy Counter in the navigation panel to display the
screen as shown.
Figure 115 Advanced Application > Policy Rule > Policy Counter
The following table describes the labels in this screen.
Table 63 Advanced Application > Policy Rule > Policy Counter
LABEL DESCRIPTION
Policy Select Any to display the dropped packets counters of all policies on the OLT.
Select a specific policy from the drop-down list to display the dropped packets counters of this
policy.
Port Select Any to display the dropped packets counters of all ports on the OLT.
Select a port from the drop-down list to display the dropped packets counters of this port.
Filter Select Non-Zero Only to only list the policy(ies) and port(s) that have dropped packets counters.
Show Click this to display the dropped packets counters of the policy(ies) and port(s) selected above.
Clear Click this to reset the fields to the factory defaults.
Cancel Click this to reset the fields to your previous configuration.
Index This is the index number of the entry.
Policy This field displays the name of the classifier to which this policy applies.
Classifier This field displays the descriptive name of the rule.
Port This field displays the port number.
Counter This field displays the number of packets dropped on the port.
Paging
Prev/Next Click Prev or Next to show the previous/next screen if all status information cannot be seen in
one screen.
To Next Page
Loading...
