Chapter 54 Basic Settings
OLT2406 User’s Guide
416
The following table describes the labels in this display.
54.5 Hardware Monitor Commands
Use these commands to set the speeds for individual fans or set the fan speed to automatic.
54.6 External Alarm Commands
Use these commands to configure the external alarm features on the OLT.
Table 197 show timesync
LABEL DESCRIPTION
Time Zone Displays the time zone.
Time Sync Mode Displays the time server protocol the OLT uses. It displays NO_TIMESERVICE if the time
server is disabled.
Time Server IP Address Displays the IP address of the time server.
Time Server Sync Status Displays the status of the connection with the time server.
NONE: The time server is disabled.
CONNECTING: The OLT is trying to connect with the specified time server.
OK: Synchronize with time server done.
FAIL: Synchronize with time server fail.
Table 198 Hardware Monitor Commands
COMMAND DESCRIPTION M P
fan <0-100>
Specifies the fan module on which you want to
configure the fan speed.
Sets the fan’s duty cycle percentage from
0~100%.
E
fan auto
Sets the fan speed to automatic. The fan speed
is adjusted automatically according to
temperatures sensed by the hardware monitor
IC.
E
Table 199 External Alarm Commands
COMMAND DESCRIPTION M P
kick tcp <session id>
Disconnects the specified TCP session.
session id: Display the session ID by running
the show ip tcp command.
E13
external-alarm <index> name
<name_string>
Sets the name of the specified external alarm.
index: 1 ~ 4
name_string: Enters a name of up to 32 ASCII
characters.
C13
no external-alarm <index>
Removes the name of the specified external
alarm input.
C13
To Next Page
Loading...
