ZyXEL Communications OLT2406 - Page 415

Chapter 54 Basic Settings
OLT2406 User’s Guide
415
This example sets the current date, current time, time zone, and daylight savings time.
This example looks at the current time server settings.
Table 195 Time Sync Commands
COMMAND DESCRIPTION M P
show timesync
Displays time server information. E 3
timesync server <ip>
Sets the IP address of your time server. The OLT
synchronizes with the time server in the following
situations:
• When the OLT starts up.
• Every 24 hours after the OLT starts up.
• When the time server IP address or protocol
is updated.
C13
timesync <daytime|time|ntp>
Sets the time server protocol. You have to
configure a time server before you can specify
the protocol.
C13
no timesync
Disables timeserver settings. C 13
Table 196 Precision Time Protocol Commands
COMMAND DESCRIPTION M P
show timing-reference ptp
Displays whether the IEEE 1588 Precision Time
Protocol is enabled or disabled.
E3
timing-reference ptp
Enables IEEE 1588 Precision Time Protocol. C 13
no timing-reference ptp
Disables IEEE 1588 Precision Time Protocol. C 13
OLT2406# configure
OLT2406(config)# time date 06/04/2007
OLT2406(config)# time timezone -600
OLT2406(config)# time daylight-saving-time
OLT2406(config)# time daylight-saving-time start-date second Sunday
--> March 2
OLT2406(config)# time daylight-saving-time end-date first Sunday
--> November 2
OLT2406(config)# time 13:24:00
OLT2406(config)# exit
OLT2406# show time
Current Time 13:24:03 (UTC-05:00 DST)
Current Date 2007-06-04
OLT2406# show timesync
Time Configuration
-----------------------------
Time Zone :UTC -600
Time Sync Mode :USE_DAYTIME
Time Server IP Address :172.16.37.10
Time Server Sync Status:CONNECTING