Chapter 76 Multicast
OLT2406 User’s Guide
545
Figure 270 MVR Multicast Television Example
76.8 General MVR Configuration
Use the mvr <vid> command to create multicast VLANs and select the receiver port(s) and a source
port for each multicast VLAN. Use the show mvr command to display the settings.
Note: You can create up to five multicast VLANs and up to 256 multicast rules on the OLT.
Note: Your OLT automatically creates a static VLAN (with the same VID) when you create a
multicast VLAN.
The following table describes the MVR commands.
OLT2406# show mvr
Behavior: IGMP Snooping
Multicast Vlan Registration Status
MVLAN: 10 Active: Yes Mode: Dynamic 802.1p Priority: 0
Name Source Port Receiver Port
------------ ------------------------------- ------------------------------
msc-1-1, msc-1-2 ge-5-1
Table 279 General MVR Configuration Commands
COMMAND DESCRIPTION
show mvr
Shows the MVR status. E 3
show mvr <vlan-id>
Shows the detailed MVR status and MVR group
configuration for a VLAN.
vlan-id: 1 ~ 4094
E3
mvr behavior <0|1>
Selects MVR behavior on the OLT. Choices are 0
for IGMP Snooping and 1 for IGMP Proxy.
C13
mvr <vlan-id>
Enters config-mvr mode for the specified VLAN
ID (1 to 4094). Creates the MVR, if necessary.
C13
8021p-priority <0-7>
Sets the IEEE 802.1p priority of outgoing MVR
packets.
C13
group <name-str>
Sets the MVR multicast group name.
name-str: 1-32 English keyboard characters
C13
inactive
Disables the MVR settings. C 13
mode <dynamic|compatible>
Sets the MVR mode (dynamic or compatible). C 13
To Next Page
Loading...
