Chapter 26 AAA
OLT2406 User’s Guide
217
26.4 TACACS+ Server Setup
Use this screen to configure your TACACS+ server settings. See RADIUS and TACACS+ on page 215 for
more information on TACACS+ servers. Click on the TACACS+ Server Setup link in the AAA screen to view
the screen as shown.
Figure 131 Advanced Application > AAA > TACACS+ Server Setup
Delete Check this box if you want to remove an existing RADIUS server entry from the OLT. This entry is
deleted when you click Apply.
Accounting
Server
Use this section to configure your RADIUS accounting server settings.
Timeout Specify the amount of time in seconds that the OLT waits for an accounting request response
from the RADIUS accounting server.
Index This is a read-only number representing a RADIUS accounting server entry.
IP Address Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
UDP Port The default port of a RADIUS accounting server for accounting is 1813. You need not change
this value unless your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS accounting server and the OLT. This key is not sent over the network. This key
must be the same on the external RADIUS accounting server and the OLT.
Delete Check this box if you want to remove an existing RADIUS accounting server entry from the OLT.
This entry is deleted when you click Apply.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 76 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
