ZyXEL Communications OLT2406 - GARP Command Examples; GVRP Commands

Chapter 56 VLAN
OLT2406 User’s Guide
448
56.8.2 GARP Command Examples
In this example, the administrator looks at the OLT’s GARP timer settings and decides to change them.
The administrator sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds, and the
Leave All Timer to 11000 milliseconds.
56.9 GVRP Commands
The following section lists the commands for this feature.
OLT2406# show garp
GARP Timer
------------------------
Join Timer :200
Leave Timer :600
Leave All Timer :10000
OLT2406# configure
OLT2406(config)# garp join 300 leave 800 leaveall 11000
OLT2406(config)# exit
OLT2406# show garp
GARP Timer
------------------------
Join Timer :300
Leave Timer :800
Leave All Timer :11000
Table 222 GVRP Commands
COMMAND DESCRIPTION M P
show vlan1q gvrp
Displays GVRP settings. E 13
vlan1q gvrp
Enables GVRP. C 13
no vlan1q gvrp
Disables GVRP on the OLT. C 13
interface port-channel <aid>
Enters config-interface mode for the specified
port(s).
aid: <msc|ge|pon>-<slot>-<port>
C13
gvrp
Enables this function to permit VLAN groups
beyond the local OLT.
C13
no gvrp
Disable GVRP on the port(s). C 13