Chapter 93 OLT Configuration
OLT2406 User’s Guide
646
CHAPTER 93
OLT Configuration
93.1 Overview
Use these commands to configure settings on a line card port interface.
93.2 OLT Configuration Commands
This table lists commands for OLT settings.
Table 348 OLT Configuration Commands
COMMAND DESCRIPTION M P
interface olt <aid>
Sets OLT configuration for the specified
interface.
aid: pon-<slot>-<port>
C13
O7-state <sn> Has the ONT with the specified serial number
enter Emergency Stop State (O7). Emergency
Stop State is a ONU state defined in ITUT G.983. In
this state, ONU will stop its transceiver output
until the OLT requests it to exit from the state.
sn: ONT serial number, 16 characters.
C13
bip-err-th <threshold> Sets the threshold for Bit Interleaved Parity (BIP)
errors.
threshold: 0~4294967295
C13
exit Leaves from the configuration commands. C 13
fec <0|1> Enables the Forward Error Correction (FEC)
feature.
0: disable
1: enable
C13
fec-corr-byte-th <threshold> Sets the FEC corrected byte threshold.
threshold: 0~4294967295
C13
fec-corr-code-word-th <threshold> Sets the FEC corrected code word threshold.
threshold: 0~4294967295
C13
fec-uncorr-code-word-th <threshold> Sets the FEC uncorrected code word threshold.
threshold: 0~4294967295
C13
inactive Inactivates the OLT PON port. C 13
To Next Page
Loading...
