Chapter 99 ERPS
OLT2406 User’s Guide
695
99.2 ERPS Commands
This table lists the commands for this feature.
Table 368 ERPS Commands
COMMAND DESCRIPTION M P
show erps-ring
Displays the status of all ERPS rings. E 3
show erps-ring <1|2|3>
Displays ERPS ring status for the specified ring. E 3
erps
Enables the ERPS feature. C 13
no erps
Disables the ERPS feature. C 13
erps-ring <1|2|3>
Enters the ERPS configuration sub commands to
configure the specified ERPS ring.
<1|2|3>: ring 1|ring 2|ring3
C13
ringId <ringid>
Sets the ring ID for ERPS packets. One ERPS ring
can include up to 16 nodes.
ringid: 0-15, default 0
C13
port0 <aid>
Specifies an uplink port as port 0.
aid: msc-<slot>-<port> | <T1> | <T2>
C13
port1 <aid>
Specifies an uplink port as port 1.
aid: msc-<slot>-<port> | <T1> | <T2>
C13
rplneighbor <port0|port1>
Sets port 0 or port 1 as the RPL neighbor node. C 13
rplowner <port0|port1>
Sets port 0 or port 1 as the RPL owner. C 13
revertivemode <enable|disable>
Use “enable” to activate the revertive switching
mode. In revertive mode, after the conditions
causing a switching are cleared, the RPL will be
blocked again.
Use “disable” to deactivate the revertive
switching mode, In non-revertive mode, after
the conditions causing a switching are cleared,
the traffic channel continues to use the RPL.
C13
wtr <1-12>
Sets the WTR (wait to restore) timer interval. WTR
timer is the time interval that the traffic channel
has to wait before re-blocking the RPL. After the
conditions causing a switch have cleared, the
traffic channel is prepared to restore to the
working transport entity. If a defect is cleared,
the traffic channel reverts after the WTR time
expires.
1-12 minutes, default 5 minutes
C13
tunnelport <port0|port1>
Sets port 0 or port 1 as the BPDU tunnel port. C 13
no port0
Deletes port 0, CCM port 0 and R-APS protocol
port 0 configuration.
C13
no port1
Deletes port 1, CCM port 1 and R-APS protocol
port 1 configuration.
C13
no rplneighbor
Removes the RPL neighbor port setting. C 13
no rplowner
Removes the RPL owner port setting. C 13
no tunnelport
Removes the BPDU tunnel port setting. C 13
no ccm <port0|port1>
Removes the ERPS CCM configuration. C 13
To Next Page
Loading...
