Chapter 29 PPPoE
OLT2406 User’s Guide
264
29.3.6 Simulation
Use this screen to start or stop a PPPoE client test to simulate the ONT creating a PPPoE session and
getting an IP address from the PPPoE server. Up to 1 session can be simulated at a time.
Click the Simulation link in the Intermediate Agent screen to display the screen as shown.
Figure 160 Advanced Application > PPPoE > Intermediate Agent > Simulation
The following table describes the labels in this screen.
Option 82
Remote Id
This field displays the option 82 Remote ID information that is added in the PPPoE discovery
packets for this VLAN.
Delete Select an entry’s check box to select a specific entry.
Delete Select the entries you want to remove and click Delete to remove them.
Cancel Click Cancel to clear the check boxes.
Table 107 Advanced Application > PPPoE > Intermediate Agent > Option 82
LABEL DESCRIPTION
Table 108 Advanced Application > PPPoE > Intermediate Agent > Simulation
LABEL DESCRIPTION
Mode(*) Select Start to start a PPPoE client test to simulate the ONT creating a PPPoE session and getting
an IP address from the PPPoE server. Otherwise, select Stop to stop the PPPoE client test.
AID(*) Select an ONT that you want to test.
username(*) Enter the user name of the PPPoE account.
password(*) Enter the password of the PPPoE account.
vlan(*) Enter the Service Node Interface (SNI) SVID on subscriber port (ONT) in the range of 1 to 4094.
This is the outer VLAN on the service node interface.
To Next Page
Loading...
