Chapter 29 PPPoE
OLT2406 User’s Guide
265
snicvid Enter the Service Node Interface (SNI) CVID setting on subscriber port (ONT) in the range of 1 to
4094. This is the inner VLAN on the service node interface.
nnisvid Enter the NNI SVID setting on subscriber port (ONT) in the range of 1 to 4094. This is the outer VLAN
on the network to network interface.
univid Enter the UNI VID setting on subscriber port (ONT) in the range of 1 to 4094. This is the (outer)
VLAN on the user node interface.
ontid Enter the ONT ID to be added to the PPPoE IA information (1-128).
ontcardid Enter the ONTCARD ID to be added to the PPPoE IA information (1-16).
uniport Enter the UNIPORT value to be added to the PPPoE IA information (1-128).
ontsn Enter the ONT serial number to be added to the PPPoE IA information (16 HEX characters long).
timeout Enter the timeout value for the simulation in the range of 10 to 300 seconds. The default value is
30 seconds.
Apply Click Apply to start or stop the PPPoE client test.
Cancel Click Cancel to reset the fields.
Simulation Result Click the Renew button to renew the result of the PPPoE client test.
AID This displays the ONT’s ID.
Snisvid This displays the SNI SVID on subscriber port (ONT).
Status This displays the PPPoE client simulation results.
IP This displays the IP address that the ONT gets from the PPPoE server.
Table 108 Advanced Application > PPPoE > Intermediate Agent > Simulation
LABEL DESCRIPTION
To Next Page
Loading...
