ZyXEL Communications OLT2406 - Document Command Syntax Conventions; Entering Partial Commands

Chapter 51 CLI Introduction
OLT2406 User’s Guide
397
5 Copy and paste the results into a text editor to create a list of all the executable commands in configure
mode and the other sub modes such as the config-vlan mode.
51.5.1 Entering Partial Commands
A command can be abbreviated to the smallest unique string that differentiates it from other
commands. For example, abbreviate the “show lc status” command to sh lc st.
Enter a unique part of a command and press
[TAB] to have the OLT automatically display the full
command. For example, if you enter con and press
[TAB], the full command of configure automatically
displays. Enter a partial command that is not unique and press
[TAB] to list the commands that start with
the partial command. The following example shows both.
51.6 Document Command Syntax Conventions
Command descriptions in this guide follow these conventions:
• Commands are in
courier new font.
OLT2406# config
OLT2406# help
Commands available:
help
logout
exit
history
enable <0-14>
enable <cr>
disable
configure
mgmt-ont-img
fan <0-100>
fan auto
renew dhcp snooping database <tftp://host/filename>
renew dhcp snooping database <cr>
clear loopguard <cr>
clear logging
clear arp inspection filter
clear arp inspection log
clear arp inspection statistics <cr>
clear arp inspection statistics vlan <vlan-list>
clear interface <aid>
clear ip arp <cr>
clear ip arp interface port-channel <port-list>
clear ip arp ip <ip-address>
-- more --, next page: Space, continue: c, quit: ESC
OLT2406# c
cdr-flush clear configure copy
OLT2406# co
configure copy