ZyXEL Communications OLT2406 - Management Switching Card Control; Management Switching Card Control Commands; Management Switching Card Control Overview

Chapter 97 Management Switching Card Control
OLT2406 User’s Guide
688
CHAPTER 97
Management Switching
Card Control
97.1 Management Switching Card Control Overview
This chapter describes management switching card redundancy status and control commands.
The OLT can use two management switching cards. If one management switching card fails, the other
one becomes active and takes over.
97.2 Management Switching Card Control Commands
The following section lists the commands for this feature.
Table 364 Management Switching Card Control Commands
COMMAND DESCRIPTION M P
show msc
Displays management switching card state and
firmware version information from execution
mode.
E 3
msc <cr>
Displays management switching card state and
firmware version information from configuration
mode.
C13
msc sync ras
Synchronizes the running firmware on the
standby management switching card with the
running firmware on the active management
switching card.
C13
msc update-target [ standby | all ]
Has the OLT apply firmware and romfile updates
by FTP or TFTP.
Sets the update target to apply to only the
standby management switching card or all
management switching card cards.
C13