Chapter 56 VLAN
OLT2406 User’s Guide
444
The following section lists the commands for the ingress checking feature. Enable or disable VLAN ingress
checking on each port individually via the ingress-check command in the config-interface mode.
The following section lists the commands for the VLAN monitor counter feature. You can display the
monitor counter for all or a specified VLAN.
56.6.1 VLAN Command Examples
This example configures ports 1 to 5 as fixed and untagged ports in VLAN 2000.
This example deletes entry 4 in the static VLAN table.
Table 217 Ingress Check Commands
COMMAND DESCRIPTION M P
interface port-channel <aid>
Enters config-interface mode for the specified
port(s).
aid: <msc|ge|pon>-<slot>-<port> | <
<msc|ge|pon>-<slot>-<port>&&-<port>
C13
ingress-check
Enables ingress checking on the specified ports.
The OLT discards incoming frames for VLANs that
do not include this port in its member set.
C13
no ingress-check
Disables ingress checking on the specified ports. C 13
Table 218 Monitor Counter Commands
COMMAND DESCRIPTION M P
show monitor-counter all
Displays all VLAN monitor counters. E 3
show monitor-counter <vlan-id>
Displays the VLAN monitor counter for the
specified VLAN.
E3
clear interface <aid>
Clears all statistics from the interface status.
aid: <ge|msc|pon>-<slot>-<port>
E13
OLT2406 (config)# vlan 2000
OLT2406 (config-vlan)# fixed 1-5
OLT2406 (config-vlan)# untagged 1-5
OLT2406 (config)# no vlan 4
To Next Page
Loading...
