ZyXEL Communications OLT2406 - Configuring MAC Forced Forwarding

Chapter 12 MAC Forced Forwarding
OLT2406 User’s Guide
127
The following table shows some possible subnet masks using both notations.
12.2 Configuring MAC Forced Forwarding
Use this screen to manage MAC forced forwarding profiles. These profiles define a static forwarding
table that lets you forward matched traffic to specific access routers or servers.
Click Advanced Application > MAC Forced Forwarding to display the configuration screen as shown.
Figure 80 Advanced Application > MAC Forced Forwarding
The following table describes the labels in this screen.
Table 33 Alternative Subnet Mask Notation
SUBNET MASK
ALTERNATIVE
NOTATION
LAST OCTET
(BINARY)
LAST OCTET
(DECIMAL)
255.255.255.0 /24 0000 0000 0
255.255.255.128 /25 1000 0000 128
255.255.255.192 /26 1100 0000 192
255.255.255.224 /27 1110 0000 224
255.255.255.240 /28 1111 0000 240
255.255.255.248 /29 1111 1000 248
255.255.255.252 /30 1111 1100 252
Table 34 Advanced Application > MAC Forced Forwarding
LABEL DESCRIPTION
Active Select the check box to enable MACFF (MAC Forced Forwarding) on the OLT.
Apply Click Apply to save your changes to the OLT’s run-time memory. The OLT loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VID Enter the VLAN ID of the hosts.