Chapter 8 Basic Setting
OLT2406 User’s Guide
98
8.3 General Setup
Use this screen to configure general settings such as the system name and time. Click Basic Setting >
General Setup in the navigation panel to display the screen as shown.
Figure 62 Basic Setting > General Setup
MIN This field displays this fan's minimum speed measured in Revolutions Per Minute (RPM) when the
OLT was first turned on. "<41" is displayed for speeds too small to measure (under 2000 RPM).
Threshold This field displays the minimum speed at which a normal fan should work.
Status Normal indicates that this fan is functioning above the minimum speed. Error indicates that this
fan is functioning below the minimum speed.
Voltage(V) The power supply for each voltage has a sensor that is capable of detecting and reporting if the
voltage falls out of the tolerance range.
Current This is the current voltage reading.
MAX This field displays the maximum voltage measured when the OLT was first turned on.
MIN This field displays the minimum voltage measured when the OLT was first turned on.
Threshold This field displays the percentage tolerance of the voltage with which the OLT still works.
Status Normal indicates that the voltage is within an acceptable operating range at this point;
otherwise Error is displayed.
Table 17 Basic Setting > System Info (continued)
LABEL DESCRIPTION
To Next Page
Loading...
