ZyXEL Communications OLT2406 - ONT Bandwidth Group

Chapter 38 ONT Template
OLT2406 User’s Guide
305
38.2.1 ONT Bandwidth Group
Use this screen to configure bandwidth group settings for ONTs. Click ONT Bwgroup in the Advanced
Application > ONT Template screen to display the screen as shown.
Figure 185 Advanced Application > ONT Template > ONT Bwgroup
The following table describes the labels in this screen.
Loop Guard This field displays if the loop guard feature is enabled on the ONT or not.
Storm
Threshold
This field displays the maximum rate in packets per second (pps) that packets are allowed to
arrive at the remote ONT.
PlanVersion This displays the ONT’s plan version.
Ontcard ID These are the virtual card ID numbers (1-16 possible) of the ONT.
Ontcard Type This displays the ONT virtual card type.
10_100BASET: for Ethernet ports on an ONT to use 10 Mbps or 100 Mbps.
VEIP: for a virtual Ethernet card on a router mode ONT.
POTS: for a virtual VoIP card on an ONT.
VDSL2: for VDSL ports on an MDU.
10_100_1000BASET: for Ethernet ports on an ONT to use 10 Mbps, 100 Mbps, or 1000 Mbps.
VIDEO: for a virtual video card on an ONT.
Uniport This displays the numbers of the ports on the ONT.
Speed This displays the speed of the physical path termination point.
PMenable This displays whether PM (performance monitoring) is enabled or not on the virtual card type.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring the screen again.
Table 131 Advanced Application > ONT Template
LABEL DESCRIPTION
Table 132 Advanced Application > ONT Template > ONT Bwgroup
LABEL DESCRIPTION
Choose the GPON interface that you want the settings configured here to apply to from the first
drop-down list.
Choose the template that you want the settings configured here to apply to from the second
drop-down list.
ID Enter the bandwidth group ID number.