Chapter 2 Hardware Installation
OLT2406 User’s Guide
49
Figure 21 Pulling the Card Out
2.5 Transceiver Installation
Use the following steps to install an SFP or SFP+ module in a slot.
For slots that are at an angle; do not attempt to straighten it.
1 Remove the dust cover from the transceiver.
2 For transceivers with a flip-up or flip-down latch, close the latch.
3 Insert the fiber-optic cables into the transceiver (you may need to remove the cable dust covers).
4 Insert the transceiver into the slot with the exposed section of PCB board facing down.
5 Press the transceiver firmly until it clicks into place.
To Next Page
Loading...
