Chapter 25 Multicast
OLT2406 User’s Guide
206
25.3.2 Mcast Channel
Use this screen to configure a GPON client multicast channel. Click Advanced Application > Multicast >
Multicast Setting in the navigation panel. Click the Mcast Channel link to display the screen as shown.
Figure 123 Advanced Application > Multicast > Multicast Setting > Mcast Channel
The following table describes the labels in this screen.
Index This is the index number of the IGMP snooping VLAN entry in the table. Click on an index
number to view more details or change the settings.
Name This field displays the descriptive name for this VLAN group.
VID This field displays the ID number of the VLAN group.
Delete Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the entry(ies) that you want to remove, then click the Delete button.
Cancel Click Cancel to clear the check boxes.
Table 71 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN (continued)
LABEL DESCRIPTION
Table 72 Advanced Application > Multicast > Multicast Setting > Mcast Channel
LABEL DESCRIPTION
Mcast-Channel
Active Select this to have the settings configured here take effect.
Name Enter a descriptive name for the entry.
start-group-ip Specify the beginning IP address of the multicast IP address range. The range of addresses
must be between 224.0.0.0 and 239.255.255.255.
end-group-ip Specify the ending IP address of the multicast IP address range. The range of addresses must
be between 224.0.0.0 and 239.255.255.255.
vlan Enter the VLAN ID; the valid range is between 1 and 4094.
pbit Select the IEEE 802.1p priority level to add to the untagged frames of this multicast channel.
To Next Page
Loading...
