Chapter 27 IP Source Guard
OLT2406 User’s Guide
236
Figure 140 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
The following table describes the labels in this screen.
27.8 ARP Inspection Log Status
Use this screen to look at log messages that were generated by ARP packets and that have not been
sent to the syslog server yet. To open this screen, click Advanced Application > IP Source Guard > ARP
Inspection > Log Status.
Table 88 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
LABEL DESCRIPTION
Show VLAN range Use this section to specify the VLANs you want to look at in the section below.
Enabled VLAN Select this to look at all the VLANs on which ARP inspection is enabled in the section below.
Selected VLAN Select this to look at all the VLANs in a specific range in the section below. Then, enter the
lowest VLAN ID (Start VID) and the highest VLAN ID (End VID) you want to look at.
Apply Click this to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified above.
Received This field displays the total number of ARP packets received from the VLAN since the OLT
last restarted.
Request This field displays the total number of ARP Request packets received from the VLAN since
the OLT last restarted.
Reply This field displays the total number of ARP Reply packets received from the VLAN since the
OLT last restarted.
Forwarded This field displays the total number of ARP packets the OLT forwarded for the VLAN since the
OLT last restarted.
Dropped This field displays the total number of ARP packets the OLT discarded for the VLAN since the
OLT last restarted.
To Next Page
Loading...
