ZyXEL Communications OLT2406 - Changing the In-Band Management IP Address; Changing the Out-Of-Band Management IP Address; Prohibiting Concurrent Logins

Chapter 52 Initial Setup
OLT2406 User’s Guide
401
52.4 Prohibiting Concurrent Logins
By default the OLT allows multiple concurrent CLI sessions as follows.
Use no multi-login to prohibit concurrent logins and not allow a console port and Telnet access
control sessions to coexist. The console port has higher priority than Telnet.
52.5 Changing the In-band Management IP Address
The OLT has a different IP address in each VLAN. By default, the OLT has VLAN 1 with IP address
192.168.1.1 and subnet mask 255.255.255.0. Change the management IP address in a specific VLAN. This
example changes the management IP address in VLAN 1 to 172.16.0.1 with subnet mask 255.255.255.0.
Note: Afterwards, you have to use the new IP address to access the OLT.
52.6 Changing the Out-of-band Management IP Address
This example changes the out-of-band management (MGMT port) IP address to 10.10.10.1 with subnet
mask 255.255.255.0 and default gateway 10.10.10.254
Table 191 Access Control Overview
CONSOLE PORT SSH TELNET FTP SNMP
One session Share up to eight sessions One session No limit
OLT2406# configure
OLT2406(config)# no multi-login
OLT2406# configure
OLT2406(config)# vlan 1
OLT2406(config-vlan)# ip address 172.16.0.1 255.255.255.0
OLT2406# configure
OLT2406(config)# ip address 10.10.10.1 255.255.255.0
OLT2406(config)# ip address default-gateway 10.10.10.254