ZyXEL Communications OLT2406 - Logging in; Ssh; Using Shortcuts and Getting Help

Chapter 51 CLI Introduction
OLT2406 User’s Guide
395
Make sure your computer IP address is in the same subnet, unless you are accessing the OLT through
one or more routers.
51.2.4 SSH
1 Make sure your computer can access the OLT.
2 Use an SSH client program to access the OLT. If this is your first login, use the default values in Table 189
on page 395 and the user name and password on the cover of this document. Make sure your
computer IP address is in the same subnet, unless you are accessing the OLT through one or more
routers.
51.3 Logging In
Use the user name and password on the cover of this document for the first login.
Note: The OLT automatically logs you out of the management interface after five minutes of
inactivity. If this happens to you, simply log back in again.
51.4 Using Shortcuts and Getting Help
This table identifies some shortcuts in the CLI and how to get help.
Table 189 Default In-band Management IP Address
SETTING DEFAULT VALUE
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Table 190 CLI Shortcuts and Help
COMMAND/KEY(S) DESCRIPTION
history
Displays a list of recently-used commands.
 (up/down
arrow keys)
Scrolls through the list of recently-used commands. You can edit a command or press
[ENTER] to run it again.
[CTRL]+u
Clears the current command.
[CTRL]+Z
Returns to the previous mode.
[TAB]
Auto-completes the keyword you are typing if possible. For example, type config, and
press
[TAB]. The OLT finishes the word configure.
?
Displays the keywords and/or input values that are allowed in place of the ?.
help
Where available, this option displays the commands that are allowed in place of help.